Abicor Binzel iROB 301, Оригинальная инструкция по эксплуатации

Страница: 153 / 160

iROB
®
501, iROB
®
401, iROB
®
301 13 IFR-800 fieldbus connection tool
EN - 73
9–10 – Welding current If the displayed measured value for offset 8/bit 7 has a
value of 0, the currently activated setting is defined.
If the displayed measured value for offset 8/bit 7 has a
value of 1, the measured value is set. Currently, fine
adjustment of the welding voltage for synergetic mode is
always set to 0.
11–12 – Wire feed speed
13–14 – Welding voltage
15
– Fine adjustment of
welding voltage for
synergetic mode
16–17 – Wave frequency The currently activated setting is defined.
18 0–6 Function (port 1) no. The currently activated setting is defined.
18 7 Function (port 1)
display change
19–20
– Function (port 1) setting
value
21 0–6 Function (port 2) no.
21 7 Function (port 2)
display change
22–23 – Function (port 2) setting
value
24
7 Function (port 3)
display change
25–26 – Function (port 3) setting
value
27 0–6 Function (port 4) no.
28–29 – Function (port 4) setting
value
30–31
– Fault code If a fault occurs or a warning is issued, a fault code is
defined.
 Tab. 38 Fault code on page EN - 73
Tab. 38
Fault code
Fault code Description
0 No fault or “Acknowledge operation stop/fault” is in effect.
1–999 This value corresponds to the "E ***" fault codes.
 Tab. 19 Fault codes on the control panel and their remedy on page EN - 55
1001
Watchdog fault
1002 Reception error from the fieldbus communication device to the control
component of the device.
1003 Warning in case of reception error from the fieldbus communication device to the
control component of the device (the warning is issued if the reception error is
reset immediately after the error occurs).
1004 Transmission error from the control component of the device to the fieldbus
communication device.
1101
Welding mode warning. The specified welding mode does not exist.
1102 Save location number warning. A save location number outside the valid range
was specified or an attempt is made to load a welding condition that was not
saved.
1103 Warning for welding mode switch during welding. Issued if an impermissible
welding mode is indicated during welding. (The warning is automatically
canceled when the welding process is ended.)
1111 Warning if weld start, wire feed, wire retract, gas discharge, or weld detection is
already set to ON and watchdog mode is activated or an error is reset. The
warning is reset when all elements are set to OFF.
Tab. 37 Details of input data
Offset Bit Function Description