Abicor Binzel iROB 301, Оригинальная инструкция по эксплуатации

Страница: 149 / 160

iROB
®
501, iROB
®
401, iROB
®
301 13 IFR-800 fieldbus connection tool
EN - 69
6 – Arc characteristic Specifies the arc characteristic.

7.4.1 Setting the arc characteristic on page EN - 33
7 – En ratio Specifies the En ratio. The unit for this setting is [%].
The En ratio is the ratio between the negative and positive
polarized part of the electrode during AC welding.
Available only with iROB
®
401.
8 0 Voltage setting for
synergetic mode
When set to 1, the synergetic mode is used for the voltage
setting.
 Setting the welding voltage on page EN - 32
In addition, the voltage settings of offsets 13 and 14 are
deactivated and offset 15 is activated for fine adjustment of
the welding voltage in synergetic mode.
8
1 Setting for wire feed
speed
When set to 0, offsets 9 and 10 are activated for the
welding current. When set to 1, offsets 11 and 12 are
activated for the wire feed speed.
 F24: Setting the wire feed speed on page EN - 39
8 2 Setting for wire feed-
in rate
The setting for this bit is only enabled when the setting for
the wire feed-in rate for offset 8/bit 1 is 0 (welding current
setting). When this is bit 1, wire feed-in with the setting for
the wire feed-in rate for offset 11 and 12 is performed only
in wire feed and wire retract modes. When this is bit 0, the
wire feed-in rate is set in relation to the welding current
setting.
If the setting for the wire feed-in rate for offset 8/bit 1 is 1
(setting for wire feed-in rate), wire feed and wire retract are
performed with the settings for the wire feed-in rate for
offsets 11 and 12.

Tab. 36 Settings for wire feed-in rate on page EN - 71
9–10 – Welding current Specifies the welding current. The unit for this setting is [A].
For information on how to apply this setting value, refer to
the description of the setting for the wire feed speed
for offset 8/bit 1 and the setting for the wire feed speed for
offset 8/bit 2.
11–12 – Wire feed speed Specifies the wire feed speed. The unit of this setting
is [0.1 m/min] or [inch/min]. (according to the device
display). For information on how to apply this setting value,
refer to the description of the setting for the wire feed speed
for offset 8/bit 1 and the setting for the wire feed speed
for offset 8/bit 2.
13–14
– Welding voltage Specifies the welding voltage. The unit for this setting
is [0.1 V]. For information on how to apply this setting value,
refer to the description of the setting for voltage synergy
(offset 8/bit 0).
15 – Fine adjustment of
welding voltage for
synergetic mode
Specifies the synergetic mode for the welding voltage.

Setting the welding voltage on page EN - 32
For information on how to apply this setting value,
refer to the description of the setting for voltage synergy
(offset 8/bit 0).
16–17 – Move frequency
(not available for
iROB
®
301)
Specifies the move frequency.

7.4.3 Adjusting the move frequency on page EN - 33
The unit for this setting is [0.1 Hz].
Tab. 29 Details of output data
Byte Bit Function Description