Abicor Binzel iROB 301, Оригинальная инструкция по эксплуатации

Страница: 152 / 160

EN - 72
13 IFR-800 fieldbus connection tool iROB
®
501, iROB
®
401, iROB
®
301
Tab. 37 Details of input data
Offset Bit Function Description
0 0 Weld start Becomes 1 if the welding start signal is detected.
0
1 Wire feed Becomes 1 if wire feed is actually performed.
0 2 Wire retraction Becomes 1 if wire retraction is actually performed.
0 3 Gas rinsing Becomes 1 if gas rinsing actually occurs (also during
welding).
0 4 Weld detection Becomes 1 if the weld detection is actually active. If this
bit is "1", the value for the weld detection result in
offset 1/bit 4 is valid.
0
7 Watchdog The watchdog signal of the output data is returned.
1 0 WCR Becomes 1 if the welding current output signal is
detected.
1 1 READY Becomes 1 when the device is ready for operation.
1 2 Inverter output Becomes 1 when an output voltage (applied welding
voltage between the output terminals) is present from the
inverter of the main circuit.
1
4 Weld detection result Becomes 1 if a welding process (short circuit) is detected
during weld detection.
1 6 Warning Becomes 1 if a warning is issued. A warning is different
from a fault because operation of the device is not
stopped.
1 7 Fault Becomes 1 if a fault is issued. Operation of the device is
stopped.
2 – Save location number
for welding condition
(job memory)
The value specified in the output data corresponds to the
actual value at the relevant point in time.
3
0 Load job memory Instructions to load the job memory is sent via the output
data. After that, the value is set to 1 if no fault has
occurred.
3 1 Write job memory Instructions to write the job memory is sent via the output
data. After that, the value is set to 1 if no fault has
occurred.
3 7 Permission to change
settings
The value specified in the output data corresponds to the
actual value at the relevant point in time.
4 0–1 Travel speed The currently activated welding mode is set.
4
2–4 Welding procedure
4 5–7 Shielding gas type
5 0–3 Welding wire material
5 4–6 Welding wire diameter
5
7 Penetration control
6 – Arc characteristic The currently activated setting is defined.
7 – En ratio
8 0 Voltage setting for
synergetic mode
8
1 Setting for wire feed
speed
8 2 Setting for wire feed
speed
8 7 Measurement displayed In welding, wire feed and wire retract modes,
offsets 9–15 are displayed as measurements and this bit
is set to 1.