Abicor Binzel iROB 301, Оригинальная инструкция по эксплуатации

Страница: 104 / 160

EN - 24
7 Operation iROB
®
501, iROB
®
401, iROB
®
301
7 Operation
► Set the main switch to <I>.
7.1 Administrative settings
7.1.1 Password-protecting the welding parameters
Activating this function protects against the following operating errors on the welding power source control
panel:
— Changing the welding parameters (it is still possible to check the settings)
— Operating the <Parameter selection> button and the <Parameter setting> knob
If the password function is activated, it remains active even after the device is switched on again via internal
functions.
Assigning a password
The password must be a three-digit number. “000” is not accepted as a password.
► Make a note of the password and keep it in a safe place.
A forgotten password can only be reset by ABICOR BINZEL.
► To cancel password setting, set the main switch to <0>.
NOTICE
Material damage due to exceeding the maximum duty cycle
If the device is operated for longer than the maximum duty cycle, it may be overloaded and irreparably
damaged.
► Only operate the device up to the maximum permissible duty cycle.

4.4 Technical data on page EN - 16
► Observe the maximum duty cycle for welding components.
1
Set the main switch to <0>.
2
Press and hold the <Function> and <Enter> buttons
simultaneously and set the main switch back to <I>.
Keep both buttons pressed until <PAS → Loc> are
displayed alternately in the left digital display.
3
Release the buttons when <Loc> is displayed.
If a password has not yet been assigned, <Loc> is displayed.
Continue with step
(5)
.
If a password has already been assigned, <Loc> flashes.
Continue with step
(4)
.
4
To change the password, first enter the old password as
described below and press <Enter>.
If the number matches the stored password, both digital
displays show <good>. The new password can be entered
as described below.
5
Set the hundreds digit with the <Parameter setting> knob.
6
Press the <Parameter selection> button.
The tens digit starts to flash.
F
+
A
m/min.
sec.
Hz
±
V
%
JOB.No.
A
m/min.
sec.
Hz
±
V
%
JOB.No.