BAL.0193.0 • 2018-07-31
EN - 19
MT/AUT/AUT RAB
10 Troubleshooting
10 Troubleshooting
Please observe the attached ‘Warranty’ document. In the event of any doubts and/or problems,
please contact your retailer or the manufacturer.
DANGER
Risk of injury and machine damage when handled by unauthorized persons
Incorrect repair work and changes of the product may lead to significant injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Operating, maintenance, cleaning and repair work may be carried out only by qualified
personnel (in Germany see TRBS 1203).
DANGER
Risk of burns
Risk of burns from hot coolant and hot surfaces.
• Switch off the coolant recirculator before starting maintenance, servicing, assembly,
disassembly or repair work.
• Allow the welding torches to cool down.
• Wear the correct protective gloves.
NOTICE
• Please also consult the operating instructions for the welding components, such as the
power supply, welding torch system, re-circulating cooling unit, etc.
Problem
Cause
Solution
Torch becomes to
hot
• Contact tip / Tip adapter loose
• Check and tighten
• Power connections loose on the torch
side and toward the work-piece
• Check and tighten
• Coolant flow to low
• Check cooling system, increase
coolant flow
Wire burned solid
in the contact tip
• Wrong parameters set
• Check or correct setting
• Worn-out contact tip
• Replace
• Adjust wire burn-back function
• Correct
Tab. 11
Troubleshooting
