EN - 11
ABIMIG
®
5 Putting into operation
8
at the front of the torch handle
so that it is flush.
9
Unscrew the nut
.
10
back out.
11
Cut the front of the liner
back 40 mm (or 53 mm if using the sealing plug
) and grind it to an angle of 40°. The liner’s insulation must not be
further removed in either case.
12
Deburr the cutting edges.
13
Screw the insulating piece
hand tight into the torch neck seat (small
edge first).
14
Push in the liner
.
The remaining excess length of the nipple (approx. 14 mm) of the liner
used to preload the liner.
15
Screw on the nut
.
5.4.2 PA liner
For using aluminium, copper, nickel and stainless steels.
Fig. 3 Mounting the liner for ABIMIG
1
Disconnect the cable assembly
on the machine side and lay it out
straight.
2
Unscrew the nut
from the central connector
.
3
Sharpen the start of the PA liner to an angle of 40° using an
ABICOR BINZEL
sharpener.
4
ABIMIG
®
A LW/ABIMIG
®
W or with undivided wire guide:
Slide the sharpened liner into the contact tip up to the stop.
ABIMIG
®
A T LW:
Slide the sharpened liner into the torch neck liner up to the stop (with the
torch neck mounted).
ABIMIG
®
W T:
Slide the sharpened liner through the wire conduit into the insulating bush
of the torch handle up to the solid stop.
5
Push the retaining nipple, O-ring and nut
onto the PA liner.
NOTICE
• New, as yet unused PA liners have to be abridged to the actual length of
the cable assembly.
• For PA liners with an outer diameter of 4.00 mm, the capillary tube in the
distance adaptor must be replaced with a guide tube.
Содержание ABIMIG A155
Страница 21: ...DE 21 ABIMIG 9 Entsorgung...
Страница 79: ...ES 21 ABIMIG 9 Eliminaci n...