Abicor Binzel ABIDRIVE V2, Инструкция по эксплуатации

Страница: 55 / 136

TIG cold-wire feeder 6 Putting into operation
BAL.0415.0 • 2018-10-22
EN - 23
7 Attach the full-floating axles (4) and close the pressure rocker (5) .
8 Fold the pressure lever (1) back into the vertical position.
Use the pressure lever (1) to set the necessary contact pressure.
9 Close the cover.
6.11 Connecting the torch and the welding device
The wire feeder can be controlled using an appropriate standard torch.
The welding power source can be optionally triggered by the start welding signal from the wire feeder. The signal occurs via
pins 1+2 (X2).

6.4.4 4-cycle and interval with torch for controlling the power source via the feed on page EN-16
If welding is started via pins 1+2, the wire feed and welding process can both be started using rocker T2 on the welding
torch. This mode is recommended for automated welding as the wire feed and the welding process can be started via one
signal.
For manual welding, the welding process is started using the separate torch trigger.

Fig. 18 Standard torch activates the power source via pins 5+6 on page EN-23
Fig. 18 Standard torch activates the power source via pins 5+6
Fig. 19
Wire on
Power on
Up wire Down wire
n.c.
n.c.
n.c.
n.c.
n.c.
n.c.
n.c.
BN
GN
WH
GY
PK
YE
Neutral
T1 = 1+3
T2 = 1+2
T3 = 1+4
T4 = 5+6
T1
T2
T3
T4
Control lead
(shielded)
Amphenol con
14-pin
6
2
5
3
4
1
7
8
9
10
11
12
13
14
F5=A
F5=b
F5=C
KDW S
KDW S
KDW S
Start wire feed
Start wire feed
Start wire feed
X1
X1
X1
1
1
1
2
2
2
3
3
3
4
4
4
Wire feed
Wire retraction
T2
T2
T2
T1
T1
T1
T3
T3
T3
UP wire feed
DOWN wire retraction
UP wire speed
DOWN wire speed