Abell Adrenaline 3D V2, Руководство пользователя

Страница: 9 / 19

with the fuselage. Once you are certain that the wing is positioned correctly apply a small
amount of Abell Hobby Super Gold + to the points where the front and rear of the wing meet the
fuselage and then where the fuselage sides meet the wing and again where the fuselage sides
meet the fuselage. Then spray the glue joints with Abell Hobby Insta Set Accelerator. (Hint; only
use enough glue to hold the components in place, final gluing will be done in a later step)
Slide the horizontal stabilizer into the fuselage. Now place the wing and fuselage assembly on
your work surface so that the wing and horizontal stabilizer are flat on the surface and the
fuselage hangs over the edge as shown. Find the center fuselage side pieces and lightly glue in
place making sure that they are properly aligned with the wing and stabilizer. (Hint; slide the
assembly towards the edge of your work surface so that the fuselage makes contact with it. This
will help hold the fuselage straight and support the side pieces during installation.) Now position
the horizontal stabilizer so that it makes contact with the fuselage side pieces and is centered and
square to the fuselage. Lightly glue into place using just enough glue to hold the pieces in place,
final gluing will be done later. (Hint; if the horizontal stabilizer will not slide far enough forward
to make good contact with the fuselage side pieces it may be necessary to sand off the point on
the front of the stabilizer flat.)
(Hint; make sure to place some sort of weight on the wing tip to keep your AF37 V2 from
flipping off of the table.
Now re install the hinges, aileron and elevator. DO NOT GLUE ! Now look at the entire
airframe very closely checking for proper alignment of all components. Make sure that the wing
and horizontal stabilizer are square to the fuselage both laterally and horizontally. Also look
down the fuselage from front to back to see if the wing lines up with the horizontal stabilizer.
Make any adjustments necessary. Now you can final glue the wing and horizontal stabilizer to
the fuselage on both the top and bottom side. Final glue the front and center fuselage sides to the