Abell Adrenaline 3D V2, Руководство пользователя

Страница: 16 / 19

receiver. Fasten the receiver to the fuselage with the provided 3m Hook & Loop. Mount the
speed controller to the fuselage in the same way. See the pictures below. (Hint; use the large
heat shrink tube to hold the wires in place.)
10) Pushrods and Linkage . Now turn on your transmitter and connect your battery to the speed
controller. Now check to make sure that all of the servos are running the correct direction (make
adjustments to servo rotation direction if necessary) set all trims and sub trims to “0” and install
the servo arms onto the servos making sure that they are centered (use your sub trims to help
center the servo arm). (
Note ; verify that the motor is turning in the correct direction, if it is not,
reverse any two of the three wires that connect the motor to the speed controller) Next find the 8
nylon clevis’s and install them onto the servo arms and control horns. Position the rudder,
elevator and ailerons so that they are in their neutral position (0 degrees deflection) and secure
with masking tape. Determine pushrod lengths by measuring from the clevis on the servo arm to
the clevis on the corresponding control horn. Cut pushrods from the small carbon fiber rod.
(Note! The Carbon Fiber pushrods should be long enough so they protrude 1/8
”
into the center of
each clevis.) . Install the white pushrod guides onto the elevator and rudder pushrods ( Note ;
Pushrod should go through the outer hole of the pushrod guide) Install the pushrods into the
clevises for each control surface.
Once you are certain that the servo arm is centered and the control surface is centered, apply two
drops of Abell Hobby Super Gold + to the pushrod where it enters the clevis and also the point