Abell Adrenaline 3D V2, Руководство пользователя

Страница: 14 / 19

Test fit the control horns making sure that the pegs fit into the predrilled holes. Remove the
control horns and apply Abell Hobby Super Gold + glue to the area that the control horns will
contact and reinstall the control horns. Apply Abell Hobby Super Gold + glue to the control horn
clip and push the clip onto the control horn pegs on the opposite side of the ailerons and spray
Abell Hobby Insta Set to cure the glue.
Draw a 1” line 3/4” away from the fuselage on the bottom of the left elevator half. Make a mark
on the line 7/16” and 7/8” back from the leading edge of the elevator and drill the marks with a
5/64” drill bit. Draw a 1” line on the right side of the rudder ½” away from the bottom of the
rudder. Make a mark on the line at 7/16” and 7/8” and drill the marks with a 5/64” drill bit.
( Note ; the 5/64” holes are drilled through the foam and the hinge in the control surface) Glue the
control horns into place as before with Abell Hobby Super Gold + glue and Insta Set.