Abell Adrenaline 3D V2, Руководство пользователя

Страница: 10 / 19

fuselage, wing and stabilizer. (Hint; when final gluing move the fuselage side away from the side
of your work surface so that the glue doesn’t wick through the joint and glue your plane to the
table)
Bore hinge gluing holes into wing and horizontal stabilizer and glue hinges in place and spray
with Insta Set. Slide ailerons and elevator half’s onto hinges, bore holes and glue.
Remember to
spray the Insta Set on the glue joints and where the pivot point of the hinge meets the foam to
prevent the glue from wicking into the hinges.
Find the two remaining flat carbon strips and glue to the bottom of the fuselage sides, wing and
horizontal stabilizer as shown starting ½” ahead of the elevator hinge line. Cut off the excess
carbon fiber strips flush with the front of the front fuselage sides and save.