Abell Adrenaline 3D V2, Руководство пользователя

Страница: 8 / 19

Locate the horizontal stabilizer and two elevator half’s. Bevel the trailing edge of the horizontal
stabilizer with the beveling tool. Mark the bottom of each component with masking tape as
shown to avoid confusion later on. Measuring from each end of the horizontal stabilizer mark the
center of the hinge locations at ¾” and 3 ¼” on both elevator half’s and the horizontal stabilizer.
Cut the hinge slots and temporarily install the hinges into the horizontal stabilizer and then the
elevator half’s onto the hinges.
DO NOT GLUE !
7) Assemble components . Locate the + shaped motor mount that is included with the Scanner RC
3213–1250 Brushless Motor. Attach the fuselage sides to the motor mount as shown below.
Then attach the front motor mount assembly to the fuselage.
DO NOT GLUE !
Now place the wing assembly and horizontal stabilizer assembly on your work surface. Remove
the left aileron, left stabilizer and hinges. Slide the main wing into the fuselage. Position the
wing so that it is centered and square to the fuselage making sure that the front of the wing is
making full contact with the fuselage side pieces and that the side pieces are making full contact