Abell Adrenaline 3D V2, Руководство пользователя

Страница: 5 / 19

Remove the rudder. Position the hinges in the vertical stabilizer so that the hinge just begins to
appear in the holes that you bored into the foam. Put two drops of Abell Hobby Super-Gold +
Foam Safe glue into each of the bored holes on the vertical stabilizer. Slide the hinges into
position making certain that they are aligned properly. Insert the foam plugs and spray with
Insta-set to cure the glue. (Hint; when spraying the Insta-set, be sure that you also spray where
the pivot point of the hinge meets the foam. This will prevent the glue from wicking into the
hinge joint) Now slide the rudder onto the hinges and repeat the gluing procedure as before.
5) Install fuselage spars. Find two of the four flat carbon fiber sticks. Using the Abell Hobby
Super Gold + and Insta Set, Glue one of the flat carbon strips to the top edge of the fuselage
starting at the base of the vertical stabilizer and the other to the bottom edge of the fuselage
starting ¼” ahead of the rudder hinge line. Trim off the excess with a cut off wheel. (Hint;
supporting the fuselage vertically as shown below makes this an easy task)