ABB IRBP, Руководство по эксплуатации продукта

Страница: 147 / 334

3.9.2 Removing or changing fixtures
Introduction
If there is a difference between the loads on each side of the positioner IRBPK,
then special care must be taken when removing or changing fixtures or workpieces.
Note
The values for Max load difference between sides 1 and 2 are listed in the
technical data in Product specification - IRBP /D2009 .
Load difference sides 1 and 2 does not exceed specified maximum value
If the positioner is in a horizontal position or not at the end of the working range
when removing or changing fixtures, make sure that the value of
Max load difference
sides 1 and 2 is not exceeded.
Fixtures can be installed in any positioner position.
Load difference sides 1 and 2 exceeds specified maximum value
If the weight of the fixture exceeds the value of Max load difference sides 1 and 2 ,
run the positioner to the working range end when positioner side 2 is oriented
towards the operator side (positioner side 1 is toward the welding robot). Then the
positioner cannot move further downwards when the first fixture is removed.
1 Remove the fixture on positioner side 1.
2 Remove the fixture on positioner side 2.
3 If changing fixtures, then install the new fixture on side 2 and finally the new
fixture on side 1.
WARNING
Do not move the positioner before both fixtures are removed or replaced by new
fixtures!
Note
If the fixtures must be installed in another position then the positioner must be
supported on the surfaces shown with arrows in the graphic below.
Continues on next page
Product manual - IRBP /D2009 147
3HAC037731-001 Revision: T
© Copyright 2010-2020 ABB. All rights reserved.
3 Installation and commissioning
3.9.2 Removing or changing fixtures