Parameterization
66 FSM4000
D184B140U02
Submenu/parameter
Value range
Comment
Submenu
Primary
Type
of
primary
Display the connected flowmeter model: The selection is
imported with the FRAM automatically by the transmitter.
If an older flowmeter sensor model (see list) is selected,
the FRAM with Cs = 100%, Cz = 100% must be used.
The models 10D1422 (10DI1425, 10DS3111A-C
≥
DN
500) can only be connected to a specially designed
connection board on the transmitter. Close switch S903
on the connection board. The other models are put into
operation with their assigned FRAM. For this reason,
when older model sensors are connected to the
transmitter, a "Primary Setup" menu is displayed at initial
startup. Additional settings can be entered in the system
data submenu "Primary". See chapter 11.
DS2_,
DS4
Frequency
View only
Display the mains frequency for which the flowmeter
sensor was calibrated. Displayed only for 50/60 Hz older
models. Not displayed, if new flowmeter sensor is
selected.
50 Hz
Meter size
View
only
1 mm 1/25 in
1,5 mm 1/17 in
2 mm 1/12 in
3 mm 1/10 in
4 mm 5/32 in
6 mm 1/4 in
8 mm 5/16 in
10 mm 3/8 in
15 mm 1/2 in
20 mm 3/4 in
25 mm 1 in
32 mm 1-1/4 in 40
mm 1-1/2 in
50 mm 2 in
65 mm 2-1/2 in
80 mm 3 in
100 mm 4 in
125 mm 5 in
150 mm 6 in
200 mm 8 in
250 mm 10 in
300 mm 12 in
350 mm 14 in
400 mm 16 in
450 mm 18 in
500 mm 20 in
600 mm 24 in
700 mm 28 in
750 mm 30 in
800 mm 32 in
900 mm 36 in
1000 mm 40 in
Display the flowmeter size. Not displayed, if no flowmeter
type is selected (sensor type = none).
1 mm 1/25 in
