14 Upon reception
Manual Energy Storage Inverter ESI-S
−
Fix an appropriate lifting device to the eyebolts to lift the inverter from the
wooden support. It can then be positioned at the desired location (see
Figure 10: Lifting an ESI-S unit by using the lifting lugs
3.5 Identification tag
Each ESI-S is fitted with nameplates for identification purposes.
The inverter nameplate is located at the top left of the master panel door, at the outside.
The nameplate information should always remain readable to ensure proper
identification during the life of the inverter. The main inverter nameplate includes the
inverter type, the nominal voltage range and frequency as well as a serial number and an
ABB internal article code.
3.6 Storage
If your ESI-S is not installed once unpacked, it should be stored in a clean indoor, dry,
dust free and non-corrosive environment. The storage temperature must be between
-25°C (-13°F) and 70°C (158°F) with a maximum relative humidity of 95%, non-
condensing.
Table 2: Maximum allowed ambient conditions for storage
Storage (in the protected package)
Temperature
-25 to 70°C (-13 to 158°F)
Relative humidity
Max. 85%
Contamination levels
(IEC 60721-3-3)
Chemical class 3C3
(a)
Mechanical class 3S3
(b)
Remarks:
(a)
Locations with normal levels of contaminants, experienced in urban areas with industrial
activities scattered over the whole area, or with heavy traffic.
(b)
Locations without special precautions to minimize the presence of sand or dust. Also
applies to locations in close proximity to sand or dust sources.
