Configuration
Power Panel FT50 User's manual V1.19
73
Load configuration from PLC
(button)
This function searches for controllers in the network that have a valid configuration for a Power Panel. After the
search is complete (a few seconds), the discovered controllers are listed:
Startup
Network
Time
Screen
Audio
Gesture
VNC
Web
Storage
Update
Backup & Reset
Server 1
IP 10.0.0.1
MAC: 00 60 65 10 12 01
Server 2
IP 10.0.0.2
MAC: 00 60 65 10 12 02
Server 3
IP 10.0.0.3
MAC: 00 60 65 10 12 03
Server 4
IP 10.0.0.4
MAC: 00 60 65 10 12 04
Server 5
IP 10.0.0.5
MAC: 00 60 65 10 12 05
When selecting an entry, a list with the configurations of all Power Panels for the selected controller is displayed:
Startup
Network
Time
Screen
Audio
Gesture
VNC
Web
Server 1
IP 10.0.0.1
MAC: 00 60 65 10 12 01
Config1
Config2
Config3
Config4
Server 2
IP 10.0.0.2
MAC: 00 60 65 10 12 02
IP 10.0.0.3
The names of the listed configurations match the names of the configurations in Automation Studio:
If a configuration entry is selected, a dialog box appears requesting confirmation for installing the configuration.
After the data is loaded, the application changes to service page
Save & Exit
, and the data can be saved using
a corresponding command. Alternatively, the user can check and – if necessary – modify the loaded settings on
any of the service pages before saving.
Load boot logo / animation
(button)
If no USB storage medium is connected, an appropriate message is displayed.
If a USB storage medium is connected, then a dialog box with USB interface IF3 and the name of the USB memory
device is displayed. After selection, the boot logo and/or boot animation are loaded and stored on the Power Panel.
The following syntax must be used for filenames:
File type
Filename
Boot logo
PPTLogo.bmp.gz (see
)
Boot animation
PPTLogoA.gif (see
)
If a boot logo and/or boot animation are already on the Power Panel, they will be overwritten.
