AAP Elite S series, Руководство по эксплуатации

Страница: 8 / 32

8
Once Stay mode has been Armed, the Stay Mode exit delay will apply.
When armed, if a zone is triggered the Stay Mode entry delays will also
apply. If, however you press the
<ENTER> button following Arming of Stay
mode, this will cancel the exit delay so the system is armed immediately
and also cancel ALL entry delay times so all zones will become Instant
zones. This allows you to select whether you wish the Stay Mode to Arm
with or without delays every time you arm this mode.
DISARMING STAY MODE
Disarming Stay Mode will turn off all Stay Mode detectors in the Area or
Areas that were Armed. To Disarm Stay Mode press;
<STAY>
Area A,B or both armed LED’s will turn OFF or
<CODE><ENTER>
Area A,B or both armed LED’s will turn OFF .
The single button disarm of stay mode indicated above is a programmable
option selectable at individual keypads so you will need to check with your
installer how your system has been configured. Disarming using the Stay
button can be programmed not to work if the panel is in alarm. If the button
is programmed this way, when in alarm you must use your code to disarm.
If the panel is programmed for <Stay> <Code> <Enter> for arming stay
mode and the code and keypad are assigned to both areas the selective
disarming method described on page 5 will apply.
BYPASSING ZONES
The Bypass button allows you to temporarily bypass zones of your choice
prior to arming your panel. The bypassed zones will revert back to normal
the next time you disarm the panel unless it is a 24 hour zone. A bypassed
24 hour zone will remain bypassed until the bypass is manually removed
by reversing the procedure shown below. To bypass a zone (say Zone 1)
from the system, follow the instructions below.
To bypass zone 1, key in the following sequence:
<BYPASS>
Bypass LED will turn ON.
<01>