AAP Elite S series, Руководство по эксплуатации

Страница: 13 / 32

13
REMOTE COMMAND CONTROL OPERATION
HOW REMOTE COMMAND CONTROL WORKS
Another powerful feature available from your alarm is Command Control.
This feature is a remote control facility which allows valid users to access
the panel via a standard touch tone telephone and check or change the
Arm/Disarm status of each of the areas, operate each of the eight outputs,
turn on an optional Microphone or force a test call to the Central Station.
On entry of a valid 4 digit DTMF code from a remote telephone the panel
will respond with an audible prompt to indicate if the function being con-
trolled is on or off. The audible prompts can be in the form of tones or
voice messages. The Command Control feature with tone prompts is stan-
dard on all panels (one Long Tone for OFF or three short beeps for ON).
. If the optional Voice Board is fitted the prompts are pre-recorded voice
messages.
Please talk to your installer to find out which of the above may be set-up in
your panel.
To perform any of the Command Control features you must first ring the
phone number which the panel is connected to. The panel may be set up
to answer after a specific number of rings of it may be set-up to use a fax
defeat option. Either way, when you ring the phone number and the panel
answers the call, the first thing you will hear over the phone is a burst of
modem tones for two seconds. The panel will then pause for a period of 5
seconds and listen for DTMF tones from the remote phone. During the
pause you must enter the access code which is associated with the Com-
mand menu option you wish to access.
Remember, the code you enter
will determine which menu option you access . If you miss the pause, the
panel will repeat the modem tones and then pause again for 5 seconds
looking for your access code. This process will be repeated 4 times be-
fore hanging up if no valid code is received. When entering codes or other
information in Command Control the "#" key acts as a "
Clear " button.
When you have entered the required 4 digit access code the panel will
reply with the status message associated with the Command Control func-
tion you have accessed. For example, if the DTMF code for Arming & Dis-
arming of Area A was “2045”, once this code has been received the panel
checks the current status of Area A and replies with the appropriate tone
or pre-programmed voice message relating to that status e.g. if Area A is
Armed then you will either hear 3 short beeps or the Armed voice mes-
sage. If Disarmed, you will hear either 1 long beep or the Disarmed mes-
sage. If there is no voice board fitted, you will only hear the tones.
Once the status message has informed you of the actual state, you can