AAP Elite S series, Руководство по эксплуатации

Страница: 11 / 32

11
special function, if the <ENTER> button is pressed when a zone is un-
sealed it will provide a two digit numeric display for all unsealed zones. Up
to 5 zones can be displayed at one time eg 01 03 07 11 14. If more than 5
zones are unsealed the keypad will alternate between each bank of up to
5 zones switching at about a 1 second rate. If you do not touch the keypad
for 10 seconds after pressing the <ENTER> button the display will auto-
matically return to the normal display mode. Alternatively if you press the
<ENTER> button again before the 10 seconds expires the keypad will re-
vert back to normal display mode.
SPECIAL CONTROL BUTTON FUNCTIONS
The <CONTROL> button on the keypad has a number of uses depending
on the options set by your installer.
It can be used to disable Chime-zone alarms or directly control any of the
outputs from the keypad.
The operation of the special <CONTROL> button functions (if enabled by
the installer) are detailed below;
DIRECTLY CONTROLLING an OUTPUT
To directly control outputs from the LED or LCD keypads press;
<CONTROL>
(Note: The Control Button must be held for 2 seconds)
The control LED will turn on at the LED keypad, the LCD display will show
If an output is currently on its number will be displayed eg if output 4 was
On then number 4 would be showing.
Now by pressing any of the buttons from 1-8 the appropriate output num-
ber will toggle On or Off each time the button is pressed. If the number is
displayed it shows that the output is on (your installer must first allow the
outputs to be directly controlled otherwise you cannot turn them On or Off
at this point).
When finished, press the <ENTER> button to exit the direct output control
mode.
OUTPUTS
__ __ __ __ __ __ __ __