AAP Elite S series, Руководство по эксплуатации

Страница: 17 / 32

17
the keypad. Entering a new code where a code already exists will delete
the old code and the new code will be displayed at the keypad.
The panel will give 3 short beeps to indicate correct entry or 1 long tone if
not accepted.
To delete or clear a user code at an LED keypad, e.g user code 3, key in
the following sequence
<PROGRAM> 1 <ENTER> 3 <ENTER> <BYPASS> <ENTER>
To delete or clear a user code at an LCD keypad, e.g user code 3, key in
the following sequence
<PROGRAM> 1 <ENTER> 3 <ENTER> <CONTROL>&<0> <ENTER>
(Note: on the LED keypad a “0” is indicated by “Aux (0)”)
CHANGING TELEPHONE NUMBERS
Your panel will accept up to 8 phone numbers with a total of 16 digits. It
can be can be programmed to dial all or any of these depending on the
event which has occurred.
(The 8 phone numbers are at program addresses P181E 1-8E)
While in CLIENT mode, key in the following sequence:
<PROGRAM> <181> <ENTER> <1> <ENTER>
(the address for telephone number 1)
Any existing number will be displayed at the keypad then press;
<NEW TELEPHONE NUMBER> <ENTER>
The new number will be displayed at the keypad.
At any time you can enter in the address for the telephone number just to
view the currently programmed value then press the <PROGRAM> button
to move on to another address.
Address P181E1E = PH # 1, P181E2E = PH# 2 to P181E8E = PH# 8.
Note: on the LED keypad “0” is indicated by the “Aux (0)” LED.