A-PLUS AUTOMATION A3-P, Инструкция по эксплуатации

Страница: 10 / 28

10
A3-P
Lifting must be done by using a specific device.
4.2 WAREHOUSING AND STORAGE PROCEDURES
• In order to avoid that the components cause dangers or are damaged, the storage area must be covered
(preferably a closed area) and accessible only for authorised personnel.
• Avoid corrosive materials that could touch the machine
• Lubricate the parts which are not painted or chromed.
4.3 UNPACKING
According to the installation requirements, the personnel authorised by the manufacturer will unpack the components
in the most suitable way and will check their integrity. Keep all packages (carton box, pallets, etc.) for future use
and dispose of the protection materials (nylon, polystyrene, etc.) according to the laws in force.
4.4 PRELIMINARY ARRANGEMENTS
In order to install the machine it is necessary to prepare a working area (a table) adequate to the machines dimensions
and the length of moulding you will be working with. To fulfill the characteristics of precision and steadiness, the
bench frame assembling machines must be positioned on a solid and leveled plane able to sustain the weight of
the machine. The bench must be studied and prepared by the customer and/or qualified staff.
4.5 PNEUMATIC CONNECTION
The machine is controlled by a dual function foot pedal.
The 3 pipes for the pedal must be inserted into the 3 fittings located on machine’s right side in the following sequence
Upper connection Red pipe into the red fitting (external side)
Central connection Blue pipe into the blue fitting (central fitting)
Lower connection White pipe into the neutral fitting (lower fitting)
Use the supplied quick disconnect
fitting to connect to the air
compressor system. You could
use also another fitting suitable
with your pneumatic system.
Once you have connected the machine to the the pneumatic system, check the operation of the foot pedal in
the following way:
• Move the vertical rod fully upwards by pressing the lever located on the side of the clamp & pull the rod
upwards. See picture 16 in section 4.8.2b
• Pressing the foot pedal half way down activates the locking of the fence, the horizontal clamp and the vertical
clamp.
• The foot pedal pressed full down activates the wedge driving.