A-PLUS AUTOMATION A3-P, Инструкция по эксплуатации

Страница: 14 / 28

14
A3-P
pressure can cause an incomplete insertion of the wedge into the frame. The working pressure is adjusted by
means of the regulator on the panel (see fig. 19). Proceed as follows to adjust the working pressure:
1. Pull up the regulator cap by about 3÷4 mm. This will unlock it.
2. Turn it clockwise to increase the pressure and counter-clockwise
to decrease it.
3. Push the regulator cap back down to lock it into position
Picture 19
DO NOT ADJUST the pressure if the machine is not connected to the air supply.
The suggested pressures are:
Soft woods (samba,. poplar, ...) 1.5 - 2.0 Bar
Medium (ramin, pine, ...) 2.0 - 3.0 Bar
Very hard woods (oak, MDF), ... 3.0 - 5.0 Bar
The above listed values apply to 7 and 10 mm high Wedges.
Increase the pressure by 10 % for 15 mm high Wedges.
When stacking 2 or more Wedges in the same position, increase the working pressure by 20%.
4.8.5 Protective shield adjustment
Machine is equipped with a protective shield made of transparent plastic material. (see fig. 20).
In order to adjust the protection shield, proceed as follows:
• Loosen the 2 knobs which hold the shield in place and lift or lower
it to a height of about 6-8 mm from the top of the moulding.
• Tighten the knobs to lock the protection shield.
picture 20
Even if the protective shield is properly adjusted, it is necessary following instructions listed below:
• Keep the fingers away from the frontal and vertical clamp working area.
• Disconnect the air supply during any maintenance intervention.
• Keep your foot off of the pedal while adjusting the machine.
For some operations, it is necessary to open the protection shield by turning it.
Opening the protection shield or the wedge magazine, the foot pedal to be deactivated and
consequently machine cannot opearate.