Directions for use
Caution:
• Before using the water heater, make sure the inner tank is completely filled with water
and the power plug has been connected properly.
• The wireless remote works with two AAA/1.5V cells.
• Ensure that the wireless remote does not get in direct contact with water. Do not
operate the remote with wet hands.
1. Initial power
When the water heater power supply plug is connected, it is in
initial power on state. The LED display on the control panel will
glow and goes off as shown in Fig. 9.
2. Power ON/OFF
To switch on/off the water heater press ON/OFF key on the
control panel or “ ” on wireless remote. While switched on the
LED display shows actual temperature of the water as shown in
Fig. 10.
Note:
The heating indicator glows when the heating element in
switched on.
3. Clock setting
The clock is Real Time Clock. Press “Set Clock” key, the hour time
(first two digits) starts blinking. Adjust the hour time by pressing
“
“ or “
“ keys and press “Set Clock” key to set the hour time
and minutes time (last two digits) starts blinking. Adjust the
Minute time by pressing “
“ or “
“ keys and press “Set Clock”
key to set the minute time. Now the clock time is set as shown in
Fig. 11.
Note:
The clock time to be set before setting the Auto On & Auto
Off time.
4. Temperature setting
Press “
“ (Increase), “
“ (Decrease) keys to adjust the Set
Temperature. Set temperature increases or decreases by 1°C for
each press from 25°C to 75°C. Wait for few seconds the value
flashes for 5 times and the new temperature value is stored. The
set temperature scrolls on pressing the keys continuously for 3
sec. The LED display glow as shown in Fig. 12.
Note:
The water is heated to the new stored temperature until
the temperature setting is changed.
5. Auto On
Press “Auto On” key, the hour time (first two digits) starts
blinking. Adjust the hour time by pressing “
“ or “
“ keys and
press “Auto On” key to set the hour time and minutes time (last
two digits) starts blinking. Adjust the Minute time by pressing
“
“ or “
“ keys and press “Auto On” key to set the minute
time. Now the clock time is set as shown in Fig. 13.
Note:
By default the “Auto On” time is 00:00 and if new time is
set the heating element will be switched on from the new “Auto
On” time irrespective of the water heater is switched on.
Fig. 9
Fig. 10
Fig. 12
Fig. 11
Fig. 13
7
