Directions for use
Caution:
• Before using the water heater, make sure that inner container is completely filled with
water and the power plug has been connected properly.
• The wireless remote works with the separate battery.
• Ensure that the wireless remote does not get in direct contact with water. Do not use
wet hands while operating the remote.
1. Initial power on
When the water heater power supply plug is connected, it is
in initial power on state, i.e the heater is ready for heating
the water. The LED display on the control panel will glow
and goes off as shown in Fig. 07.
2. Power ON/OFF
To start heating the water press ON/OFF key on the control
panel or “ ” on wireless remote. While heating the LED
display shows actual temperature of water inside the inner
container as shown in Fig. 08.
3. Increase/Decrease
To increase/ the set temperature (normal mode), Time (when
the Auto ON/Auto OFF or Clock Set) is pressed. Pressing the
Switch once will increase/decrease the set temperature by
1°C in Normal Mode.
To set the time press the “
“/ “
“ key once will
increase/decrease the min/hour by 1 each. The temperature
setting varies between 25°C to 75°C as shown in Fig. 09.
4. Energy meter
The “ENERGY METER” key is used to display the energy
consumed by water heater. The LED display is indicated for
5 seconds in kWh. The energy meter value displayed is
cumulative. The LED display as shown in Fig. 10.
Note:
• Energy Meter values are indicative only.
• Refer 6.
Reset function
to reset the Energy Meter.
5. Power select
To select the 1, 2 or 3kW power. The default power selection
is 2kW and can be changed to 1, 2 or 3kW by pressing the
power select key. The LED display as shown in Fig. 11.
6. Auto On
To set the auto on function press the “AUTO ON” key and it
shows the default on time as “00.01”. Change the time
flashing in the digital by “
“ or “
“ keys to set the hours
and minutes. By pressing the “AUTO ON” key again then
changed time in the LED display and will be set as a Auto
On time. The LED display as shown in Fig. 12.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
8
6
Control panel operations
To increase the Set
Temperature (normal
mode)
To decrease the Set
Temperature (normal
mode)
This light glows when the
water heater start heating
the water inside the tank
as shown in Fig. 7.
The LED display shows:
• Displays actual and set
temperature; indication
of timers and power
consumed.
IR connecting the water
heater and the wireless
remote
To start heating the water
press ON/OFF key. While
heating the digital display
shows actual temperature
of water inside the tank as
shown in Fig.
Fig. 7 Use of wireless remote
