A.O. Smith Jaguar HSE-SCJ-015, Руководство пользователя

Страница: 10 / 29

6. Auto Off
Press “Auto Off” key, the hour time (first two digits) starts blinking.
Adjust the hour time by pressing “
 “ or “  “ keys and press “Auto
Off” key to set the hour time and minutes time (last two digits)
starts blinking. Adjust the Minute time by pressing “
 “ or “  “
keys and press “Auto Off” key to set the minute time. Now the
clock time is set as shown in Fig. 14 .
Note: By default the “Auto Off” time is 23:59 and if new time is
set the heating element will be switched on till the new “Auto Off”
time irrespective of the water heater is switched on.
7. Energy meter
The “ENERGY METER” key is used to display the energy
consumption of water heater in kWh. The energy meter value is
displayed for 5 sec and it is cumulative. The digital display as
shown in Fig. 15.
Note:
• Energy Meter values are indicative only.
• Refer 6.
Reset function to reset the Energy Meter.
8. Power select
The water in the tank heats quick by changing the power options. The default power
selection is 2000W. It can be changed to 1000, 2000 or 3000W by pressing the power
select key. Wait for few seconds the value flashes for 5 times and the new power option is
stored. The LED display as shown in Fig. 16.
9. Override
By pressing the ”Override” key, the water heater enters the heating state instantly after the
“Auto Off” time. The heating continues until the set temperature is reached. You can exit
the heating mode by pressing the “Override” button again during the instant heating
mode. The LED display as shown in Fig. 9.
10. Reset
By pressing the “

“ and “

“ simultaneously for few seconds the water heater will change
into default stage. AUTO ON & OFF times set as 00:00 & 23:59. Power is set 2000W as
default. Set temperature set to 70°C.
11. Operation of remote controller
The operating method and function keys of the remote controller as shown in Fig. 7.
1. Prior to operating the remote controller, it is necessary to install the battery as show in
Fig. 17.
2. While the remote controller in use, point it at the electronic controller, having a range
within 5 m as shown in Fig. 18.
Note:
• Replace the batteries if the controller does not function correctly.
• Use two AAA/1.5V cells. Ensure to insert them in the correct orientation.
• When replacing the batteries, do not mix old and new or batteries of a different type.
• If the remote is not used for a long period, please remove the batteries.
Fig. 15
Fig. 16
Fig. 14
8