A-iPower SUA8000iE, Руководство пользователя

Страница: 26 / 44

OPERATION
26
A-iPower Corp. 10887 Commerce Way Unit A Fontana, CA 92337 USA
www.a-ipower.com 1-855-888-3598 or support@a-ipower.com.
STARTING YOUR GENERATOR
Before starting the generator:
1. Verify that the generator is outside on a dry, level surface. Allow at least two feet
of clearance on all sides of the generator.
THE GENERATOR
2. To maximize safety, check that the generator is properly grounded (see “ GROUND
”).
&KHFNWKHUHLVVXI¿FLHQWOHYHORIRLOLQWKHFUDQNFDVH$GGRLOLIQHFHVVDU\VHH³
ADD/CHECK OIL ”).
0DNHVXUHWKHUHLVVXI¿FLHQWOHYHORIJDVROLQHLQWKHIXHOWDQN$GGIXHOLI
necessary (see “ ADD/CHECK FUEL” ).
5. Make sure all electrical devices are unplugged from the generator during ignition.
2WKHUZLVHLWZLOOEHGLI¿FXOWIRUWKHHQJLQHWRVWDUW
Fig. 1
Fig. 4
Fig. 2
Fig. 3
To start the generator, perform the following steps:
1. Turn the LOW IDLE switch (Fig. 1) to “OFF”.
2. Turn the Multi-Switch (Fig. 2) to the
“START” position.
3a. Electric Start:
Turn the ENGINE switch to the “START”
position and hold on for 5 seconds (Fig. 3).
NOTE: If the engine does not start, release the switch
and try again. Keeping the switch in the START
position too long can damage the starter.
3b. Manual Start
Place one hand on the generator to
hold it in place,and pull on the recoil
starter handle slowly until a slight
resistance is felt (Fig. 4). Then pull
quickly to start the engine.Return cord
gently into the machine. Never allow
the cord to snap back.
4.When engine starts,turn the
Multi-Switch in to the “RUN”
position (Fig. 5).
Fig. 5