A-iPower SUA8000iE, Руководство пользователя

Страница: 24 / 44

„
Loosen the screws at the side of the
left maintenance cover. Remove
cover and set aside.
„
Mix fuel stabilizer and gasoline prior
to filling the tank by using a gas can
or other approved fuel container and
shaking gently to combine.
NOTE: To control the amount of fuel
stabilizer being added to the engine,
always mix fuel stabilizer with
gasoline before fueling the tank
rather than adding fuel stabilizer
directly into the generator’s fuel tank.
„
Replace and secure fuel tank cap.
„
Start and run the engine for at least
5 minutes to allow stabilizer to treat
the entire fuel system.
„
Unscrew the oil cap/dipstick and
remove.
„
Wipe dipstick clean and re-seat in
hole; do not re-thread.
„
Remove dipstick again and check
engine oil level. Engine oil level
should fall between the minimum and
maximum marks on the dipstick.
„
If level is low, add engine oil.
„
Replace and secure the cap/dipstick.
NOTICE:
Attempting to start the engine before it
has been properly filled with engine oil
will result in equipment failure.
CHECKING/ADDING ENGINE OIL
The generator is equipped with two
handles for easy transport. Both handles
should be used to move the generator.
USING FUEL STABILIZER
Fuel gets old, oxidizes, and breaks down
over time. Adding a fuel stabilizer (not
included) extends the usable life of fuel
and helps prevent deposits from forming
that can clog the fuel system. Follow fuel
stabilizer manufacturer’s directions for
correct ratio of stabilizer to fuel.
Engine oil has a major influence on
engine performance and service life. For
general, all-temperature use, SAE
10W-30 is recommended. Always use a
4-stroke engine oil that meets or
exceeds the requirements.
NOTE: Non-detergent or 2-stroke engine
oil will damage the engine and should
not be used.
OPERATION
24
A-iPower Corp. 10887 Commerce Way Unit A Fontana, CA 92337 USA
www.a-ipower.com 1-855-888-3598 or support@a-ipower.com.