3M
Multimedia Projector MP8610
Disassembly/Reassembly
3M 1999
2-6
6
7
1
5
2
3
4
2-3-5.
Remove Power Supply
To avoid electrical shocks, unplug projector
power cord before performing any maintenance
to electrical components.
To avoid burns to fingers, allow projector lamp
and internal projector components to cool off prior
to lamp removal or disassembly.
Remove the lens cover, top cover, and fan plenum.
1.
Remove two (2) lamp leads from the power supply
board at the fan end.
2.
Disconnect three (3) fan connectors [in a block] at the
end opposite the cooling fan.
√√
Note
The three fan cables are parallel connected, and do not
need to be placed back into the exact same connector.
3.
Disconnect the 10-pin PCB interface connector.
4.
Disconnect two (2) ground cables attached to the PCB
heat sink.
5.
Remove the 3-pin power connector.
6.
Remove three (3) philips screws.
7.
Remove the power supply.
8.
Reassemble in reverse order.
!
Caution
!
WARNING
