3DGence ONE, Руководство пользователя

Страница: 30 / 59

30 | 3DGence ONE
During the first printing there may occur some difficulties in applying the base layer of material, which is crucial for the
entire printing process. Compare your printout with the below photographs.
Photographs illustrate the following problems:
• hotend too high,
• hotend too low,
• hotend in correct position.
2. EVALUATION OF OPERATIONAL QUALITY OF PRINTER
Hotend too low
The material is pushed out of the hotend while
printing the first layer. It leads to deformation of
the base of the printed model. It’s an indication to
recalibrate the heatbed.
Hotend in correct position
The material is laid out regularly. Whole surface of
the model’s base is covered with plastic and the
upper surface of the first layer is a regular, flat and
lithe plane.
Hotend too high
The distance between the heatbed and the hotend
is too large. It causes a poor adhesion of the ma-
terial to the heatbed. It may lead to the model to
be peeled off during printing. It’s an indication to
recalibrate the heatbed.