3DGence ONE, Руководство пользователя

Страница: 29 / 59

3DGence ONE | 29 version 1.0/08.2017
First printing can be started under the following conditions:
• location of the device meets all conditions stated in chapter 4.3.,
• the device is properly connected to power supply,
• all axes and limit switches move without any obstructions,
• heatbed is properly calibrated,
• SD memory card is properly inserted,
•
filament is mounted properly,
• all readings of the printer are correct.
IV FIRST PRINTOUT
1. LAUNCHING SD CARD CODE
WARNING:
Starting the first print without meeting the conditions specified in this user manual (chapters DESCRIPTION OF
PRINTER, PREPARATION FOR WORK) can result in equipment damage or cause injury to the operator. Always
follow instructions for safe operation – even if you are an experienced operator.
Use 3DGence print testing file from the included SD memory card. For more information on file preparation, format of
files and method of conversion, see chapter SOFTWARE. The initial print will help determine if the printer is functioning
properly.
For making the first printout:
1. Turn on the device with POWER button.
2. Go to main menu by pressing “OK” button. Select the option “Print” using navigation buttons up - down on the right
panel. Confirm again by pressing ”OK” button.
3. Select „Print File” and press „OK” to confirm.
4. Now you have access to all G-code files and subfolders on SD card.
G-code files are instructions for the printer – only these files can be used for starting printing.
5. Confirm selection of one of the files by pressing „OK” button.
The printer starts heating the hotend and heatbed. After reaching the exact temperature, the device will measure the
parameter of height for the hotend. Do not press the table surface or touch the head during the measurement - it may
cause interruption or incorrect readings. Next, the device will extrude a sample strap of printing material near the edge
of heatbed. This is to ensure that the hotend is properly filled with the material before starting printing.
Depending on the selected file, the printing can take from one to three and a half hours.
• 3D_keychain – 1 hour;
• calibration XY – 1 hour 45 minutes (printing calibration solid – see chapter
„Calibration of axes”
),
• phonestand – 3 hours 30 minutes.
After the completion of printing the hotend returns to a safe position and the printout is cooled. Wait until progress bar
for cooling reaches 100%. When the printout is cooled, you can safely remove it from the heatbed. For more information
see chapter
„Post-printing operations” .
For starting any next printing, the device must be cooled down. All printing leftovers and material contaminations (pieces
of plastic, lumps in the hotend) must be removed.