![background image](http://html.mh-extra.com/html/3dgence/one/one_user-manual_442151027.webp)
3DGence ONE | 27
version 1.0/08.2017
NOTE:
The nut on the handle has a left hand thread! For loosening, spin the nut clockwise, for tightening counterclockwise!
2. Unpack the spool with the filament attached to the device.
3. Release the sealed end of the material and cut the ending with scissors or pliers. The ending cannot be crushed or deformed.
4. Place the spool on the handle.
5. Place the filament in the cleaning tool (see fi. 33). Follow the instruction below:
• remove the Bowden (tube) from the cleaner by pressing and holding the red clamping ring of pneumatic connector (2) and
pull the tube out (1);
• unscrew the cleaner’s nut (4) and remove the sponge inlay;
•
pass the filament through the hole of the cleaner’s nut (4) and pierce the sponge located in the cleaning tool with the tip of filament;
•
pass the filament through the sponge (3), insert the filament and the sponge to the cleaning tool and tighten all with the
cleaner’s nut (4);
•
push the filament wire through a tube (Bowden) (1), straighten the end of it and insert it into the cleaner’s pneumatic con
-
nector (2).
6. Select „
Load Filament
” in
Prepare
menu and follow instructions on LCD panel:
1
2
3
4
4.1. Mounting filament
1. Install in the spool holder on the right side of the device (turn counterclockwise) (fig. 32).
The device will heat up the hotend to 240°C and start extruding the printing material. Next:
• open the extruder by moving its lever to the left (counter clockwise);
•
straighten the end of filament and insert it to the hotend (min. 5 cm from the inlet of extruder);
•
close the filament inside the extruder by moving the lever right (clockwise);
•
after the printing head is sufficiently filled with the new material (approx. 5 cm of filament should be pushed through when
changing the color of the filament), press „OK” button to stop loading filament;
• remove the material leak from the head with the use of tweezers.
7. LCD panel should display information that loading filament was completed successfully. Press “OK” button to confirm.
Fig. 33. Constructing of the cleaning tool.
Fig. 32. Location of the spool holder.
1
Содержание ONE
Страница 1: ...USER MANUAL 3DGence ONE ...
Страница 2: ......
Страница 59: ...3DGence ONE 59 version 1 0 08 2017 ...