21
Version 1/2013
© Aroja s.r.o. 2013
www.3dfactories.com
14.3. Low amount of material
If you see the print result like is on the picture, probably this has two reasons.
a)
Too low material. Decrease the filament
diameter number in the material editor.
b)
Retract is too long, you can decrease length of the retract or increase the number for extra length on restart.
1)
Filament diametr is too hight and printer give too small material (2.0)
2)
Here is still low material but result is better (1.8)
3)
Seem to be good result (1.62)
4)
Too much of material, you can see debris on the border of model (1.5)
1
2
3
4
