11
Version 1/2013
© Aroja s.r.o. 2013
www.3dfactories.com
9.
BEFORE FIRST PRINT
9.1. Few steps before first print
Before print is necessary to do this few steps. Please pay attention to this.
•
Double check if the print bed is clean
•
Remove all debris and rests of material
•
Double check if the print bed is put in the right way and strongly attached
•
Double check it the nozzle is clean
•
Double check and correct height of nozzle over print bed
•
Double check if the filament is correctly put into extruder and spool is correctly put in printer
9.2. Z axis calibration
a)
Connect printer click on
.
b)
Go to “Manual control” panel and press “Home Z” button.
c)
Put common office paper under nozzle (pic 9.2.1) and with screws (pic 9.2.2) set proper position of table.
You
have to feel that nozzle is touching to the paper and a little hold it but paper have to move under cannot be
hold too much.
Do this in all positions (pic 9.2.3)
Pic 9.2.1
Pic 9.2.2
Pic 9.2.3
1
2
3
4
5
6
