17
Version 1/2013
© Aroja s.r.o. 2013
www.3dfactories.com
Extra length on restart (mm):
filament is going back to extruder after retract (length of r this number) Do not
put here too high number. Usually is O only in some cases use some like 0.1 or 0.2 no more. Filament would be broken
in extruder.
Print settings
Solid layers :
number of horizontal solid layers. Remember 0.08 layers are 12 for 1mm of thickness.
Fill pattern:
Concentric:
Linear
12.2. Cooling
Enable fan if layer print time is below:
If
approximate time of prin of one layer is below
time fan will be on from min speed to max
speed depend on time.
Slow down if layer print time is below:
If layer
time is too small and layer is too small it really
good to slow down the extruder. This is good
for cooling and prevent to melt lower layers.
Tip:
ABS print – fan can be switch off all the
time
13.3. Speed
Perimeters (mm/s):
speed for all perimeters besides the outer perimeter.
Small perimeters:
if perimeter is smaller than diam. 6mm printer will print with this speed. Is good let this value lower.
Something likes 20 to 30mm/s.
Infill:
speed of infill can be higher no problem put here 80mm/s besides layer thickness 0.25mm here let the value 40-
50mm/s
