18
Version 1/2013
© Aroja s.r.o. 2013
www.3dfactories.com
Solid infill:
speed of solid infill can be higher no
problem put here 80mm/s besides layer thickness
0.25mm here let the value 40-50mm/s
Top solid infill:
value for speed of top solid layer
can be lower. About 40-50 for precision creation of
top surface.
Bridges:
speed can be 50-80 with 0.25mm layer let
here mas speed 60mm/s
External perimeters speed
: For precision print of
outer perimeter (surface of model) let this number
lower the best is 20.
12.4. Advanced
Extrusion width :
general value for change default
thickness of single line from extruder. Default is
0.70. Usually real output is 0.5 or 0.52 but for
properly generation of lines put here value about
0.45-47. If you need print wall like for example 0.8
divide this thickness in this options 0.4 than will
be generated like two lines.
First layer extrusion width:
the same way like
before. Only for first layer. Usually is not necessary
to change it.
Perimeters extrusion width:
you can change
parameters only for perimeters by the same way
like extrusion width.
Infill extrusion width:
the same only for infill.
Support material extrusion width:
If support
seems to be too strong or too weak you can change it. If you let it 0 will be extrusion of support 0.7mm you can also
change it with % or number for example 0.4.
Bridges flow ratio:
change of material amount for bridges. Usually is not necessary to change.
