19
Version 1/2013
© Aroja s.r.o. 2013
www.3dfactories.com
Support material
Overhang threshold:
change of minimum angle for support generation. For example if you put here 40° the support
will not created for angle over 40° like 41° and higher.
Patternt spacing:
space between support lines. If you put here higher value the support will be sparser.
Pattern angle:
angle in which support will be created. Default is 90°in XY direction.
12.5. Material editor
Material editor allow to you change material
properties and add new materials.
Diameter:
This is most important value
. Because
diameter of filament is not absolutely constant and
is changed because environmental circumstances
like humidity. Is necessary to work with this value
often. Before you put material inside please
measure diameter and put this number her.
If seems to be too much of material in print
increase this number. If seems to be too small
amount of material in the print process decrease
this value. Usually we work with 1.65 – 1.8mm. But
this is a little individual.
Multiplier:
is almost the same like change the
filament diameter. Range of this value is 0.9 – 1.1.
First layer bed °C:
temperature of print bed for first print layer. ABS 75°C and PLA can be 50°C.
Bed °C:
others layers bed temperature. ABS can be 70°C and PLA can be 50°C.
First layer °C
: temperature of extruder for first layer. Usually is higher than next layer for good stick on the print bed.
With heated print bed please use the same temperature like other layers. ABS 240-250 and heated print bed 230°C.
PLA 210 and heated print bed 175°C.
Temp °C:
temperature for printing ABS 240-270°C PLA 190-220°C.
Raft °C:
not use at this time.
13.
MAINTENANCE
Hold the printer in clean and dry environment.
The body of printer cleans with dry clean cloth.
