![background image](http://html1.mh-extra.com/html/3com/nbx-100/nbx-100_administrators-manual_440814246.webp)
246
C
HAPTER
3: D
EVICE
C
ONFIGURATION
Completing the BRI-ST Configuration
To complete the BRI-ST installation:
1
Return to the
Digital Line Cards
tab.
2
From the
Select Device Type
list, select
ISDN BRI Channel List.
3
Click
Apply
.
4
Wait approximately 30 seconds for the status of each channel to change
from
Ready
to
Idle
.
If the channel status does not change to Idle, verify that you have enabled
the On Line check box for the card, the span, and the group.
While you are waiting, click
Apply
to refresh the list of channels and to
see the updated status.
BRI-ST Card Status
Lights
Each of the four spans on a BRI-ST card has status lights that indicate the
status of the span (Table 42).
Modifying a
BRI-ST Card
These sections tell you how to modify a BRI card that is already installed in
the system:
■
Modifying a BRI Span
■
Modifying Audio Controls
For the BRI-ST card, you can modify only a BRI span. You cannot modify
the board type for a BRI-ST card.
Table 42
BRI-ST Card Status Lights
Status
D
B1
B2
Off
No Layer 1 connection is
established with the Central
Office (CO).
The channel is not
carrying a call.
The channel is not
carrying a call.
Yellow
A Layer 1 connection is
established but the channel
is not yet ready to make or
receive calls.
A call build-up is
occurring.
A call build-up is
occurring.
Green
The channel is ready to make
and receive calls.
A call is connected. A call is connected.
Содержание NBX 100
