3Com CoreBuilder 3500, Справочник по командам

Страница: 94 / 784

94 C
HAPTER
3: S
YSTEM
E
NVIRONMENT
2 Enter the terminal speed setting for the serial port. See the Options table
for supported terminal speed rates.
The system response depends on the cable status.
The terminal speed is referred to as
baud rate
in the following messages.
If the cable is connected to the terminal port when you set the terminal
speed for that port, the system displays the following message:
Changing the baud rate may cause a loss of communication
since you are currently connected via the serial port.
Are you sure you want to change the baud rate? (y/n):
■
If you respond
y
(yes), the serial port’s baud rate is changed
immediately, and you lose the ability to communicate with any devices
connected to the port until you adjust the device baud setting to
match.
■
If you respond
n
(no), the rate does not change, and the display
returns to the previous menu.
Procedure (IP Interface)
1
From the top level of the Administration Console, enter:
system serialPort terminalSpeed
2 Enter the terminal speed setting for the terminal port.
The terminal speed is referred to as
baud rate
in the following messages.
After you select the new terminal speed rate, the system displays the
following message:
The baud rate will not change until the system is rebooted.
To have your change take effect without rebooting, perform
this command via the serial port.
Are you sure you want to change the baud rate? (y/n):
■
If you respond
y
(yes), the rate is not changed until you reboot.
■
If you respond
n
(no), the rate does not change, and the display
returns to the previous menu.