3Com CoreBuilder 3500, Справочник по командам

Страница: 340 / 784

340 C
HAPTER
14: V
IRTUAL
LAN
S
(VLAN
S
)
Origin For all Layer 2 systems or switching modules, the VLAN origin is
always
static
, which indicates that the user created the VLAN.
For the CoreBuilder
®
3500 or CoreBuilder 9000, the origin
indicates one of the following:
■
static
— The VLAN was created statically (user-configured
by using the
bridge vlan define
command).
■
router
— The VLAN was created automatically by a outer port
IP interface (of router origin). You create a router port IP
interface using the
ip interface define
command with
the interface type
port
. You cannot modify or remove a router
port VLAN.
■
GVRP
— The VLAN was created dynamically from a GVRP
update (
GVRP
). You must enable the GVRP state for the entire
system as a bridge-wide parameter and for the participating
bridge ports as a bridge-port parameter.
Ports Index numbers of the bridge ports that belong to the VLAN, or the
bridge port that belongs to the router port IP interface.
On the CoreBuilder 9000, the list of ports includes the front-panel
ports and the appropriate backplane ports. Example: On a 12-port
Layer 3 module, the list of ports includes ports 1 – 12 and port 13,
which is the module’s backplane port.
Type (VLAN
mode) Either
allOpen
or
allClosed
. VLANs in allOpen mode share a
single address table for all configured VLANs; in allClosed mode,
each VLAN has its own unique address table. Standard bridging
rules apply based on the table addresses that are assigned to the
specific VLAN. A router port IP interface requires that you put the
system in allClosed mode.
VID Unique, user-defined integer (VLAN ID) that identifies this VLAN. It
is used by management operations. You can assign or modify a VID
that is associated with a static VLAN; you cannot modify the VID
selected automatically after you define a router port IP interface,
nor can you change the VID of the default VLAN. The default VLAN
requires a VID of 1.
VLAN Aware
Mode
(3500 and
9000 Layer 3)
Whether the VLAN aware mode (tagging mode) is
allPorts
or
taggedVlanPorts
. The default for CoreBuilder 3500 Release
2.0 or later is
allPorts
;
allPorts
is also the default as of
CoreBuilder 9000 software Release 3.0. The value
taggedVlanPorts
is a compatibility mode for VLANs configured
prior to CoreBuilder 3500 Release 2.0 and for VLANs configured on
CoreBuilder 9000 Layer 3 modules prior to CoreBuilder 9000
Release 3.0.
Field Description