3Com 5500 SI - Switch - Stackable, Руководство по настройке

Страница: 67 / 686

Ethernet Port Configuration Introduction 67
Displaying Port
Configuration
Information in Brief
This S5500 version has a new command, display brief interface for you to display the
port configuration information in brief, including the port type, link state, link rate,
duplex attribute, link type and default VLAN ID.
Ethernet Port
Configuration Example
Networking Requirements
Switch A is connected to Switch B through Trunk port Ethernet1/0/1. Configure the
trunk port with a default VLAN ID, so that:
■
When receiving packets without a VLAN Tag, the port can forward them to the
member ports belonging to the default VLAN
■
When it is sending the packets with VLAN Tag and the packet VLAN ID is the
default VLAN ID, the trunk port will remove the packet VLAN Tag and forward the
packet.
Networking Diagram
Figure 15 Configuring the Default VLAN for a Trunk Port
Configuration Procedure
The following configurations are used for Switch A. Configure Switch B in the similar
way.
1 Enter the Ethernet Port View of Ethernet1/0/1.
[SW5500] interface ethernet1/0/1
2 Set the Ethernet1/0/1 as a trunk port and allow VLAN 2, 6 through 50, and 100 to
pass through.
[SW5500-Ethernet1/0/1] port link-type trunk
[SW5500-Ethernet1/0/1] port trunk permit vlan 2 6 to 50 100
3 Create the VLAN 100.
[SW5500] vlan 100
4 Configure the default VLAN ID of Ethernet1/0/1 as 100.
[SW5500-Ethernet1/0/1] port trunk pvid vlan 100
Table 50 Display the port configuration information in brief
Operation Command Description
Display the port
configuration information
in brief display brief interface [
interface-type [
interface-number ] |
interface-name ] [ | { begin |
include | exclude }
regular-expression ] You can execute the display
command in any view.
Switch A Switch B