3Com 5500 SI - Switch - Stackable, Руководство по настройке

Страница: 474 / 686

474 C
HAPTER
22: F
ILE
S
YSTEM
M
ANAGEMENT
6 Sending the Information to SNMP
Table 528 Sending the Information to SNMP
7 Turn on/off the information synchronization Switch in Fabric
Figure 124 Turn on/off the Information Synchronization Switch in Fabric
Sending the Information
to Loghost
To send information to the loghost, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 529 Enable/Disable Info-Center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to loghost
Perform the following operation in Table 530.
Device Configuration Default value Configuration description
Switch Enable info-center By default,
info-center is
enabled. Other configurations are valid only
if the info-center is enabled.
Set the information output
direction to SNMP - -
Set information source - You can define which modules and
information to be sent out and the
time-stamp format of information,
and so on. You must turn on the
Switch of the corresponding
module before defining output
debugging information.
Configuring SNMP features - See RMON Configuration
Network
management
workstation The same as the SNMP
configuration of the Switch - -
Device Configuration Default Value Configuration Description
Switch Enable info-center By default, info-center is
enabled. Other configurations are valid
only if the info-center is
enabled.
Set the information
output direction to
SNMP By default, Switches of master
log in Fabric, debugging and trap
information synchronization are
turned on, so as log and strap
information synchronization
Switches in other Switches. This configuration can keep
log information, debugging
information and trap
information in Fabric in every
Switch synchronized.
Operation Command
Enable info-center
info-center enable
Disable info-center
undo info-center enable