3Com 5500 SI - Switch - Stackable, Руководство по настройке

Страница: 226 / 686

226 C
HAPTER
16: IP R
OUTING
P
ROTOCOL
O
PERATION
■
Enabling RIP to Import Routes of Other Protocols
■
Configuring the Default Cost for the Imported Route
■
Setting the RIP Preference
■
Setting Additional Routing Metrics
■
Configuring Route Filtering
Enabling RIP and Entering the RIP View
Perform the following configurations in System View
By default, RIP is not enabled.
Enabling RIP on a Specified Network
For flexible control of RIP operation, you can specify the interface and configure the
network on which the interface is located to the RIP network, so that these interfaces
can send and receive RIP packets.
Perform the following configurations in RIP View.
After the RIP interface is enabled, you should also specify its operating network
segment, because RIP only operates on the interface when the network segment has
been specified. RIP does not receive or send routes for an interface that is not on the
specified network, and does not forward its interface route.
When the
network
command is used for an address, the effect is to enable the
interface of the network with this address. For example, for network 129.102.1.1,
you can see
network 129.102.0.0 either using the
display current-configuration
command, or using the
display rip
command.
By default, RIP is disabled on all interfaces.
Configuring Unicast RIP Messages
RIP is a broadcast protocol. To exchange routing information with a non-broadcast
network, unicast transmission mode must be used.
Perform the following configuration in the RIP View.
By default, RIP does not send messages to unicast addresses.
Table 202 Enabling RIP and Entering the RIP View
Operation Command
Enable RIP and enter RIP view
rip
Disable RIP
undo rip
Table 203 Enabling RIP Interface
Operation Command
Enable RIP on the specified network
network network_address
Disable RIP on the specified network
undo network network_address
Table 204 Configuring unicast RIP messages
Operation Command
Configure unicast RIP message
peer ip_address
Cancel unicast RIP message
undo peer ip_address