3Com 5000/6000, Краткое руководство пользователя

Страница: 140 / 162

140 3Com Router 5000/6000 Family
Command Reference
snmp-agent target-host
Use the
snmp-agent target-host
command to set the destination that receives SNMP notifications.
Use the
snmp-agent target-host
command in conjunction with the
snmp-agent trap enable
command.
System view
snmp-agent trap enable
Use the
snmp-agent trap enable
command to enable the device to send traps and set the trap and
notification parameters.
System view
snmp-agent trap enable encrypt-card
Use the
snmp-agent trap enable encrypt-card
command to enable SNMP agent trap function on the
encryption card.
System view
snmp-agent trap enable ldp
Use the
snmp-agent trap enable ldp
command to enable Trap function in MPLS LDP creation.
System view
snmp-agent trap enable lsp
Use the
snmp-agent trap enable lsp
command to enable Trap function in MPLS LSP creation.
System view
snmp-agent trap enable mobile-ip
Use the
snmp-agent trap enable mobile-ip
command to enable the MIP SNMP trap function. With the
function enabled, a trap packet is sent to the network management software whenever a security violation
event occurs.
System view
snmp-agent trap enable ospf
Use the
snmp-agent trap enable ospf
command to enable the TRAP function of OSPF.
System view
snmp-agent trap life
Use the
snmp-agent trap life
command to set the lifetime of traps. The expired traps are discarded
without being retained or sent.
System view
snmp-agent trap queue-size
Use the
snmp-agent trap queue-size
command to set the length of the trap queue to the specified host.
System view
snmp-agent trap source
Use the
snmp-agent trap source
command to specify the source address of traps.
System view
snmp-agent usm-user
Use the
snmp-agent usm-user
command to add a new user to an SNMP group.
System view
sot counter keepalive
Use the
sot counter keepalive
command to specify the number of keepalive checks before disconnecting
from the peer SOT entity.
System view
sot gather
Use the
sot gather
command to assign the serial interface to an existing SOT protocol group.
Synchronous Serial Interface view
sot group-set
Use the
sot group-set
command to set up a SOT protocol group.
System view
sot peer
Use the
sot peer
command to assign an IP address to the local SOT entity.
System view
sot sdlc broadcast
Use the
sot sdlc broadcast
command to configure the broadcast address FF for the connected SDLC
terminals, allowing them to receive broadcast frames.
Synchronous Serial Interface view
sot sdlc controller
Use the
sot sdlc controller
command to configure the SDLC address of a connected terminal.
Synchronous Serial Interface view