Predator ULTRA Installation Manual V2.1.25.3
Page 16
© 360 Vision Technology Ltd.
MAINS input
100 - 240Vac
L
N
E
MAINS FUSE
MAINS FUSE = 1.6AF
PRED-POE-PSU
Data In
Data
&
Power Out
RJ45 CONNECTION
TO CAMERA
RJ45 CONNECTION
TO NETWORK
255 x 180 x 100mm
Enclosure Dimensions
5 Predator Washer/Nozzle Bracket
Nozzle bracket.
The predator washer bracket kit includes the bracket, nozzle M8 plain metal washer, M8 lock washer and four
cable ties.
Nozzle Adjustment
The nozzle is set to produce a vertical water jet. The direction of the jet can be adjusted by rotating the nozzle
body in the bracket, or by using the screw-driver slot.
Fixing Bracket to Predator
Choose one of the four M8 predator fixing bolt positions to be used to mount the nozzle bracket so that it does
not obscure an important view. E.g. directly above the horizontal bar of a wall bracket would be suitable.
Fit an M8 flat metal washer between the predator base and the nozzle bracket so that the base of the bracket is
not crooked. Fit an M8 lock washer under the head of the bolt to reduce the risk of the bolt becoming loose and
the bracket moving. Ensure that the curved end of the bracket fixing plate is directed towards the Predator pan
shaft so that the vertical part of the bracket is the maximum distance from the rotating body.
Tube Connection
Suitable tube (not supplied) for connection to the nozzle is PVC with internal diameter 3mm and outside
diameter 6mm PVC.
The end of the tube is pushed over the ridged tube at the rear of the nozzle. Fit a cable tie around the joint
between the PVC tube and the rear of the nozzle to ensure that the tube can not become detached.
The PVC tube should weave through the two slots in the bracket to provide strain relief. Cable ties can be used
to secure the tube so that it is clear of the Predator’s rotating body. Take care that the cable ties do not cause
excessive restriction of the tube.
