Manual WS.502 v1.5
2-Wire Energy Monitor
12
10. LOGIC MODULE
A tab was attached to the
main menu: LOGIC
Click this tab, and a blank
grid screen appears.
At the top there are 4
buttons:
VIEW LOGIC
: If this button lights up red, you should
wait until the logic is loaded. When the green button
lights up, you can press this button. If logic has
already been introduced, the logic will be shown. If no
logic has been created, the screen remains blank.
Let's say you've already created logic, but you want to
completely start over with new logic, don't press
'VIEW LOGIC'. You start with a blank logic.
REFRESH DATA:
When you create logic, or you want
to see the current statuses of the modules, you can
press this button. Statuses are indicated by RED digits.
SAVE LOGIC:
This key definitively brings the created
logic to memory.
Attention!! There is no 'UNDO' button, which means
that this action cannot be revoked. However, a
confirmation is first requested:
If you don't want to enter the changes, press "Cancel."
EXIT:
When you decide to leave logic, the next screen
may be shown:
You then wanted to keep the logic, but printed
'Cancel'.
You can now only leave logic by reloading the page!
(reload page in browser address bar)
QUESTION:
What logic is possible?
ANSWER:
Just about every conceivable logic !
There are a number of 'prefabricated' logic modules:
Press the
LEFT MOUSE BUTTON,
and a list is shown
from the possible modules:
1.
ENERGY : these are the measuring modules of
your installation (energy modules,
temperature, calorie, water...)
2.
OR-GATE: an 'OR' port, with 4 inputs
3.
AND-GATE: an 'AND' port with 4 entrances
4.
DIFF-GATE: Switching between 2 values
5.
ADD: Add up 4 analog values