2N SmartCom, Руководство пользователя

Страница: 115 / 141

115
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Caution
Make sure that the telephone number and message parameters are
completed to set this function successfully.
TCP
Enter TCP to send the defined TCP message to the defined IP address and port.
Use telnet for TCP sending.
Note
A typical TCP sending AT command looks as follows:
At^scudf="add","AIN1>50:TCP i[62.134.22.87:8026] m[text 1]"
Caution
Make sure that the telephone number and message parameters are
completed to set this function successfully.
Warning
Make sure that the TCP receiving server exists to avoid process
slow–down due to the terminal waiting for the reply from a
non–existent server and not executing new actions.
CNT 1-5
Enter CNT 1-5 to control all of the 5 internal counters.
Note
The AT command for counter increment by 1 can be as follows, for
example:
At^scudf="add","AIN1>50:CNT1 d[1]"
Action Parameters
Use the parameters of the actions mentioned above to change the relay states and set
the address for SMS/TCP sending. Enter the parameters in the format <mark>[value]
and separate them with a space on both ends. There is no specified order for the
parameters.
IP address
Set the IP address and default port 80 for the TCP messages. To i[xxx.xxx.xxx.xxx]
change the port, enter , where is the IP address of the i[xxx.xxx.xxx.xxx:yyyyy] x
remote server and is the port to be used for TCP sending. y
Caution
Enter the IP address for the action only as it is meaningless and TCP
signalled as error for the other actions.