ZyXEL Communications ZyXEL ZyWALL USG-1000, User Manual

Page: 94 / 986

Chapter 5 Configuration Basics
ZyWALL USG 2000 User’s Guide
94
3
Name the policy route.
4
Select the interface that the traffic comes in through (ge4 in this example).
5
Select the FTP server’s address as the source address.
6
You don’t need to specify the destination address or the schedule.
7
For the service, select FTP.
8
For the Next Hop fields, select Interface as the Type if you have a single WAN
connection or Trunk if you have multiple WAN connections.
9
Select the interface that you are using for your WAN connection (ge2 and ge3 are
the default WAN interfaces). If you have multiple WAN connections, select the
trunk.
10
Specify the amount of bandwidth FTP traffic can use. You may also want to set a
low priority for FTP traffic.
Note: The ZyWALL checks the policy routes in the order that they are listed. So make
sure that your custom policy route comes before any other routes that would
also match the FTP traffic.
5.4.11 Static Routes
Use static routes to tell the ZyWALL about networks not directly connected to the
ZyWALL.
5.4.12 Firewall
The firewall controls the travel of traffic between or within zones. You can also
configure the firewall to control traffic for virtual server (port forwarding) and
policy routes (NAT). You can configure firewall rules based on schedules, specific
users (or user groups), source or destination addresses (or address groups) and
services (or service groups). Each of these objects must be configured in a
different screen.
To-ZyWALL firewall rules control access to the ZyWALL. Configure to-ZyWALL
firewall rules for remote management. By default, the firewall only allows
mangement connections from the LAN, WAN zone.
MENU ITEM(S)
Network > Routing > Static Route
PREREQUISITES
Interfaces
MENU ITEM(S)
Firewall