Chapter 13 Interfaces
ZyWALL / USG (ZLD) CLI Reference Guide
89
nd ra hop-limit
Removes the maximum number of hops setting for router
advertisements and all IPv6 packets originating from the interface.
nd ra min-rtr-interval
Removes the minimum IPv6 router advertisement transmission interval
setting.
nd ra max-rtr-interval
Removes the maximum IPv6 router advertisement transmission interval
setting.
nd ra reachable-time
Sets the amount of time a remote IPv6 node is considered reachable
after a reachability confirmation event to the default.
nd ra default-lifetime
Sets the router lifetime value included in all IPv6 router advertisements
the interface sends to the default. The router lifetime value should be
equal to or greater than the router advertisement interval.
nd ra retrans-timer
Sets the IPv6 router advertisement retransmission interval to the
default.
ipv6 address
dhcp6_profile
dhcp6_suffix_128
Removes the specified setting for having the ZyWALL / USG obtain an
IPv6 prefix from the ISP or a connected uplink router for an internal
network.
nd ra prefix-advertisement
DHCP6_PROFILE DHCP6_SUFFIX_64
Removes the specified setting for using a delegated prefix as the
beginning part of the network prefix.
dhcp6
Sets the interface’s DHCPv6 setting back to the default.
dhcp6 address-request
Has the ZyWALL / USG not get this interface’s IPv6 address from the
DHCPv6 server.
dhcp6 rapid-commit
Has the ZyWALL / USG use the full four-step DHCPv6 message
exchange process.
Note: Make sure you also disable this option in the DHCPv6 clients.
dhcp6-lease-object
dhcp6_profile
Removes the specified profile of DHCPv6 lease settings to offer to
DHCPv6 clients.
dhcp6-request-object
dhcp6_profile
Removes the specified profile of DHCPv6 request settings that
determine what additional information to get from the DHCPv6 server.
interface reset
{
interface_name
|
virtual_interface_name
|al
l}
Resets the interface statistics TxPkts (transmitted packets) and RxPkts
(received packets) counts to 0. You can use the
show interface
summary all status
command to see the interface statistics.
interface send statistics interval
<15..3600>
Sets how often the ZyWALL / USG sends interface statistics to external
servers. For example, syslog server and Vantage Report server.
show interface-name
Displays all PPP and Ethernet interface system name and user-defined
name mappings.
interface-name {
ppp_interface
|
ethernet_interface
}
user_defined_name
Specifies a name for a PPP or an Ethernet interface. It can use
alphanumeric characters, hyphens, and underscores, and it can be up to
11 characters long.
ppp_interface
|
ethernet_interface
: This must be the system name
of a PPP or an Ethernet interface. Use the
show interface-name
command to see the system name of interfaces.
user_defined_name
:
•
This name cannot be one of the follows:
"ethernet", "ppp", "vlan", "bridge", "virtual", "wlan", "cellular",
"aux", "tunnel", "status", "summary", "all"
•
This name cannot begin with one of the follows either:
"ge", "ppp", "vlan", "wlan-", "br", "cellular", "aux", "tunnel".
interface-rename
old_user_defined_name
new_user_defined_name
Modifies the user-defined name of a PPP or an Ethernet interface.
Table 37
interface
General Commands: Basic Properties and IP Address Assignment (continued)
COMMAND
DESCRIPTION
Summary of Contents for ZyWALL USG Series
