ZyXEL Communications SLC1224, User Manual

Page: 112 / 133

SLC1224 User’s Guide
112 Chapter 9 SHDSL Port Commands
This command sets the limit for how many MAC addresses a specified port may dynamically
learn.
The following example sets the MAC count filter to allow up to 50 MAC addresses to be
dynamically learned on DSL port 1 on the line card in slot 3.
Figure 59 MAC Count Set Command
9.4.21 Port Isolate Command
Syntax:
lcman port isolate [<enable|disable>]
This command turns the Integrated Ethernet Switch isolation feature on or off. Enable the
Integrated Ethernet Switch isolation to block communications between subscriber ports. When
you enable the Integrated Ethernet Switch isolation feature, you do not need to configure the
VLAN to isolate subscribers.
9.4.22 Dot1x Show Command
Syntax:
lcman port dot1x show <slot>
where
This command displays the line card’s IEEE 802.1x settings.
The following example displays the IEEE 802.1x settings for a line card in slot 4.
ras> lcman port maccount set 3-1 50
<slot>
= The number of the slot where the line card is located.